Hello,
I'm configuring a RV220W in a router mode.
I have a cisco 2911 in the other side, and I wan to connect the two site.
In lab i connect the two equipments with a cross cable.
Then configured each LAN.
After configuring it, i want to make a test (ping) from an endpoint in c2911 side and anb endpoint in the RV220W side.
Each other cannot make ping. I've tested with other FTP, but no success.
IP route is coorect,
Firewall in the rv220 is permis any any (from wan to lan, and from lan to wan)
so what is the reason it cannot ping on the RV220W.
regards,
Antra
