cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

CUBE HA state SNMP monitoring

cukouncukoun
Beginner
Beginner

Hi all,

we have 2 ISR4451 (IOS-XE) gateways configured as one CUBE HA pair. I would like to know how is it possible to monitor state of each gateway through SNMP - if its on ACTIVE,STANDBY or PROTECTED mode as you can see through CLI below.

This is very important because CUBE node which is on the PROTECTED state needs to be reloaded to start to work again as pair with the second node.

#show voice high-availability rf-client
IDLE RF DOMAIN: 0x2

-----
RF Domain: 0x0
Voice HA Client Name: VOIP RF CLIENT
Voice HA RF Client ID: 1345
Voice HA RF Client SEQ: 129
My current RF state ACTIVE (13)
Peer current RF state DISABLED (1)

Current VOIP HA state [LOCAL / PEER] :
        [PROTECTED (13) / UNKNOWN (0)]

VOIP HA RF CB Data:
        ENABLED:1
        flags: 0x6 [PEER_COMM_DOWN/PEER_PRESENCE_DOWN/IN-BOX HA]
        red_mode: 0

-----
RF Domain: 0x2 [RG: 1]
Voice HA Client Name: VOIP RG CLIENT
Voice HA RF Client ID: 4054
Voice HA RF Client SEQ: 461
My current RF state STANDBY HOT (8)
Peer current RF state ACTIVE (13)

Current VOIP HA state [LOCAL / PEER] :
        [PROTECTED (8) / ACTIVE (13)]

VOIP HA RF CB Data:
        ENABLED:0
        flags: 0x0 [PEER_COMM_UP/PEER_PRESENCE_UP/IN-BOX HA]
        red_mode: 0
        rg_flags: 0x0
                ctrl [UP/NO SHUT]
                data [UP/NO SHUT]
                traffic (TOT:2; SH:0, DN:0) [UP/NO SHUT]

-----
Voice HA Standby is not available.
System has not experienced switchover.

Thanks

Tomas

Who Me Too'd this topic