I have an AP1852E that I have started setting up. It is connected to a local trunk port on my switch, with the management VLAN configured as the native VLAN. When it first started up, the Cisco Mobility Express Provisioning ran just fine, I entered all of the revelvant information, and completed the setup. Upon reboot, the controller never successfully boots back up. I just keep seeing the following message form the console:
"waiting for uplink IP address and reachable default gateway"
I can see that the AP is pulling a DHCP address just fine, just like it did upon first setup. I have tested this using an access port on the management VLAN and the controller will start up just fine, but that does me little good. Any ideas what I need to do to get teh controller to boot up properly while connected to a trunk port? Thanks!
