cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Reimaging a Sourcefire/FirePOWER 8350 Issue

neilkolar
Level 1
Level 1

I am trying to reimage an 8350 appliance.  I have been following the guide located here: http://www.cisco.com/c/en/us/support/docs/security/firesight-management-center/118308-technote-firesight-00.html.  I can get to the point where the ISO downloads to the system but when I choose the next menu item (Run the Install) I get a screen that says "Cannot find menu.sh.  Please check your ISO."  This happens with both Sourcefire_3D_Device_S3-5.4.0-763-Restore.iso and Sourcefire_3D_Device_S3-5.3.0-571-Restore.iso.  Anyone have any suggestions?

Who Me Too'd this topic