| Firmware |
v4.2.3.07 (Oct 8 2015 15:29:55 |
I have created a new service with TCP port 8007 to 80 in the service management under UPnp section.
I already have three rules active there.
But if I create the rule then with the IP address linked to it and enable it and after that I save it, it gives me a blank Cisco screen.
I cannot refresh it without login again, if I press back I have to re-add this rule but after the save again blank screen.
Even after a restart of the router it won't work to create a new UPnP rule.
I can add forwarding rules but that's not what I need right now because I need to configure it with another internal port number.
What can I try more without the factory reset? I use the latest available firmware which I have found. v4.2.3.07 (2015)
