cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Enabling NPIV will reboot the Switch...Inmediatly?

Hi everybody

I need to enable the NPIV on a Nexus 5000, and I found how to do it in the following link,

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli/CLIConfigurationGuide/npv.html

To enable NPV, perform this task:

 

Command
Purpose

Step 1

switch# configure terminal

switch(config)#

Enters configuration mode.

Step 2

switch(config)# npv enable

 

Enables NPV mode. The switch reboots, and it comes back up in NPV mode.

Note A write-erase is performed during the initialization.

But I need to know about the reboot. It will reboot inmediatly after enabling the NPIV or I could reboot the switch when I desirre?

best Regards

Gonzalo Arroyo

Who Me Too'd this topic