I have a failed cisco 3850. I got a new switch in and the IOS was lower than my current stack so i upgraded it . When i do a show ver the IOS looks right but when i do a show switch the H/W version are different. This will cause my stack to fail ?
New switch :
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 56 WS-C3850-48P 03.07.03E cat3k_caa-universalk9 INSTALL
H/W Current
Switch# Role Mac Address Priority Version State
------------------------------------------------------------
*1 Active 15 V04 Ready
Old Switch :
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 56 WS-C3850-48P 03.07.03E cat3k_caa-universalk9 INSTALL
S
H/W Current
Switch# Role Mac Address Priority Version State
------------------------------------------------------------
*1 Active 15 V06 Ready
