07-27-2017 05:52 PM - edited 03-08-2019 11:31 AM
Hi all,
Im trying to transfer a IOS image to upgrade a 3850 switch, as soon as I put the USB drive to the front of the switch, I go to the CLI and run the command: show usb-devices summary (it is the only command available) and it shows and display the name and even the serial of the USB,
however, if I want to see the files (IOS image file) inside the USB, with the command show usbflash0:/ it does not show anything,
I tried to search for answer on the forum but no like this one, and a lot of post states that with the command: dir usbflash0:/ will display but this command is not available,
is there a command to active a usbflash0:/ slot ?
I even tried formatting the drive to FAT32 and NTFS but still the same results,
Am I missing something?
the current switch IOS image is:
Cisco IOS Software [Denali], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 16.3.1, RELEASE SOFTWARE (fc3)
Regards,
Solved! Go to Solution.