cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Slow speed with 5508-X

jeff.ghi
Level 1
Level 1

Hi Folks,

 

So we paid for a 10Mb/s line with our ISP, however we're only seeing speeds of 35-50kb/s unfortunately through the ASA

 

We only have 2 users connected and we see that CPU is only < 1%.

 

I see from the searches that alot of folks have had multiple issues with Duplex.

 

So, I'm trying to see if it may be a duplex issue:

However note that there's no Collisions that is typical of such problems even if the auto-duplex is set to half-duplex.

 

sh int Gi1/1

Interface GigabitEthernet1/1 "ISP", is up, line protocol is up
Hardware is Accelerator rev01, BW 1000 Mbps, DLY 10 usec
Auto-Duplex(Half-duplex), Auto-Speed(10 Mbps)
Input flow control is unsupported, output flow control is off
MAC address x.y.z, MTU 1500
IP address x.x.x.x, subnet mask x.x.x.x
1400642 packets input, 451439083 bytes, 0 no buffer
Received 28540 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 pause input, 0 resume input
0 L2 decode drops
1167871 packets output, 437395753 bytes, 0 underruns
0 pause output, 0 resume output
0 output errors, 0 collisions, 0 interface resets
0 late collisions, 0 deferred
0 input reset drops, 0 output reset drops
input queue (blocks free curr/low): hardware (1970/1908)
output queue (blocks free curr/low): hardware (2047/2022)

 

Are there any other checks one can do help debug why speeds are lower than expected?

Who Me Too'd this topic