Hello,
Can someone please assist me in understanding the difference between Bandwidth of a
GRE/VTI Tunnel vs the tunnel transmit/receive
bandwidth.
Here is the output for command
show interfaces tunnel1
Tunnel1 is up, line protocol is up
Hardware is Tunnel
Internet address is X
MTU 17916 bytes, BW 100 Kbit/sec, DLY 50000 usec,
reliability 255/255, txload 255/255, rxload 255/255
Encapsulation TUNNEL, loopback not set
Keepalive set (5 sec), retries 3
Tunnel source X (Loopback0), destination X
Tunnel Subblocks:
src-track:
Tunnel1 source tracking subblock associated with x
Set of tunnels with source x, 2 members (includes iterators), on interface <OK>
Tunnel protocol/transport GRE/IP
Key disabled, sequencing disabled
Checksumming of packets disabled
Tunnel TTL 255, Fast tunneling enabled
Path MTU Discovery, ager 10 mins, min MTU 92
Tunnel transport MTU 1476 bytes
Tunnel transmit bandwidth 8000 (kbps)
Tunnel receive bandwidth 8000 (kbps)
Last input 4w4d, output never, output hang never
Last clearing of "show interface" counters 40w0d
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 12894
Queueing strategy: fifo
Output queue: 0/0 (size/max)
30 second input rate 1610000 bits/sec, 1547 packets/sec
30 second output rate 2610000 bits/sec, 1774 packets/sec
26576029373 packets input, 4608367508280 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
34408453207 packets output, 5582525345540 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
Thanks much in advance
