03-19-2018 12:52 PM - edited 07-05-2021 08:24 AM
Hello,
Today I began deploying my 500 new 3802i APs, and the first 50+ went well. I moved into a different building and started hanging, and the first two I hung are blinking in the red-green-blue-off pattern, like the location option has been set... (Access point location command invoked from controller web interface.)
I have not done this. nor do i see anything on the controller that is set for this. I have defaulted the APs in the controller, and they come to back the same blink pattern.
The APs are running 8.2.151.0 code, and seem to be booting and downloaded the code just fine.
Solved! Go to Solution.