Hey all,
I'm looking for some information on how I should stack these switches. They don't have stack cables/ports, and the guide says they support virtual stacking. Unfortunately, I'm not entirely sure how to configure this. Is this speaking about clustering? I see the vstack command, but I don't see any of the vstack commands in the guide after enabling it. See here:
(config)#vstack ?
director Configure director's IP address
<cr>
(config)#do sh vstack config
Capability: Client
Oper Mode: Enabled
Role: Client
Vstack Director IP address: x.x.x.x
System image file is "flash:c2960l-universalk9-mz.152-6.E/c2960l-universalk9-mz.152-6.E.bin"
Model number : WS-C2960L-48PQ-LL
Any information you can provide is greatly appreciated. Thanks!
Matt
