So, got a brand-spankin' new Catalyst 9300. Racked it up, connected to console port with PuTTY, booted the switch. Went through the basic configuration script. When it was done, I tried to enter enable mode and found I couldn't - evidently, I fat-fingered the password.
I don't care about the config that's on there now- it's easily re-creatable. I'd like to erase the startup config and start over, but I can't seem to get there. Is there a procedure document somewhere that will tell me? I vaguely remember, with older switches, breaking into the power up routines and erasing the config from flash. Is that still possible?
