HI,
I have bought a cisco RV345 in 08/2017.
I put it in production.
I have bought a new cisco RV345 in 02/2018.
I want to copy the configuration from the old to the new.
I have an error : "configure have error. Please check again."
What's wrong ?
What is the good method to do it ?
I use firmware 1.0.01.17 on the two RV345.
I use signature 1.0.0.0849 on the two RV345.
I backup the config from the one.
I put the confing on the second.
I Have an error.
I have to restart the router after the error.
best regards
