Hi!
I'm upgrading a UC environment from 11.0 to 11.5. One of the pre-upgrade tasks is to ensure the subnet mask is in the recommended format for /24.
"If you are using a 24-bit IP subnet mask, ensure that you use the following format:255.255.255.0. Do not use the format 255.255.255.000. Although 255.255.255.000 is a valid format, it may cause problems during the upgrade process. We recommend that you change the format before you begin an upgrade to avoid possible problems. You can change the subnet mask by executing the set network ip eth0 <server_IP_address> 255.255.255.0 command. Other formats are supported for subnet masks and this limitation applies to 24-bit subnet masks only."
I have entered the command as described above but am running into the following message...
admin:set network ip eth0 10.*.*.* 255.255.255.0
Required 3 mandatory parameter(s) but 2 parameter(s) were found
Executed command unsuccessfully
Error executing command
I also tried add the GW address to the command too and get this output of no change was made...
No modfication: --ipaddr 10.*.*.* --old_ipaddr 10.*.*.*
Trying to avoid any potential for problems during the upgrade process and this subnet mask issue appears to be a known one that can cause the upgrade to fail. Any advice is greatly appreciated.
Thanks,
Mark
