Is et up a new RV345 today and allw as good until a reboot. Afterward I would just get Web Login Disabled. All I dd during setup was ad some VLANs, changed all port to use the 192.168.75.1 vlan, enabled intervlan routing, created a VPN and set up some state reservations. If I try to log into 192.168.1.1 it also says Web Login disabled.
I tried to telnet it but that didn’t work either I didn’t try ssh but I don’t even know if these SMB routers do this and if they don’t how could anything disable the web login? If there is the ability to disable web login where is this feature, in security?
It pisses me off knowing tomorrow I have to do a factory reset even though the config is minimal but this is really stupid. The other posts about fw upgrades is also pretty stupid. Why is this stuff happeneing?
