cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

Help needed: SX80 Enterenig into Permanent Maintenance Mode. No video, no full Web interface

alexgarin
Beginner
Beginner

I have SX80 codec that stopped working recently. It does power on, LED light is slowly flashing, and no video on the monitor. When connected via Web interface it shows XAPI error and says it is running in the maintenance mode (see picture attached). Via Web interface I can install another version of software, upgrade or downgrade without any problem, although I still don't see anything on the monitor (using HDMI 1 output) and codec remains in the maintenance mode.

 

Also I'm able to connect via COM port and run any command available. All seems to be OK from the COM port commands. But codec remains in permanent maintenance mode and nothing is being displayed on the monitor.

 

Is there anything I can try? I have captured complete log that I can upload, hopefully it can tell what's wrong with the codec?

 

Thank you for your help!

Who Me Too'd this topic