07-26-2018 03:28 AM
I can see the router running at 95% memory , there’s a “ license auto update “ process using all of the cpu.
Router# sh proc mem sorted holding
Processor Pool Total: 1688360784 Used: 306333648 Free: 1382027136
lsmpi_io Pool Total: 6295128 Used: 6294296 Free: 832
PID TTY Allocated Freed Holding Getbufs Retbufs Process
0 0 410367160 131747168 257960896 0 0 *Init*
64 0 1198391792 1198391792 29864 0 0 Licensing Auto U
The router details are:
#sh ver
Cisco IOS XE Software, Version 03.16.04b.S - Extended Support Release
Cisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(3)S4b, RELEASE SOFTWARE (fc1)
Suite License Information for Module:'esg'
--------------------------------------------------------------------------------
Suite Suite Current Type Suite Next reboot
--------------------------------------------------------------------------------
FoundationSuiteK9 None None None
securityk9
appxk9
AdvUCSuiteK9 None None None
uck9
cme-srst
cube
Technology Package License Information:
-----------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------
appxk9 None None None
uck9 None None None
securityk9 securityk9 Permanent securityk9
ipbase ipbasek9 Permanent ipbasek9
cisco ISR4431/K9 (1RU) processor with 1648789K/6147K bytes of memory.
Processor board ID FCZ22174018
1 Ethernet interface
4 Gigabit Ethernet interfaces
1 ATM interface
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
6598655K bytes of flash memory at bootflash:.
The inventory on the router is as follows
#sh inv
NAME: "Chassis", DESCR: "Cisco ISR4431 Chassis"
PID: ISR4431/K9 ,
NAME: "Power Supply Module 0", DESCR: "250W AC Power Supply for Cisco ISR4430"
PID: PWR-4430-AC ,
NAME: "Power Supply Module 1", DESCR: "250W AC Power Supply for Cisco ISR4430"
PID: PWR-4430-AC ,
Any ideas to get this CPU memory
NAME: "Fan Tray", DESCR: "Cisco ISR4430 Fan Assembly"
PID: ACS-4430-FANASSY , VID: , SN:
NAME: "module 0", DESCR: "Cisco ISR4431 Built-In NIM controller"
PID: ISR4431/K9 , VID: , SN:
NAME: "NIM subslot 0/1", DESCR: "NIM-VAB-A - Multi-mode xDSL with VDSL bonding and ADSL1/2/2+ Annex A over POTS"
PID: NIM-VAB-A ,
NAME: "NIM subslot 0/0", DESCR: "Front Panel 4 ports Gigabitethernet Module"
PID: ISR4431-X-4x1GE ,
NAME: "module R0", DESCR: "Cisco ISR4431 Route Processor"
PID: ISR4431/K9 ,
NAME: "module F0", DESCR: "Cisco ISR4431 Forwarding Processor"
PID: ISR4431/K9 ,
Any ideas to get this CPU memory?
Thanks
Solved! Go to Solution.