I am trying to set up a 3802i ap as an autonomous ap. I now learned that I have to run mobility express. I currently running 8.4.100 and cant get it to work. It boot up and get to the end and the light just rainbow and I never see the ssid.
So I tried to terminate the autoinstall and go manual, but the wired interface keeps flapping up and down and never connects. the rainbow lights never stop even after configuring ssid.
I did notice that this ap is only pulling 15.4 watts. I tested this on 3850s with 802.3at(30w) and UPOE (60w) and still only 15.4. this just doesn't see right.
Enabling Controller Provisioning
Configuring management interface
Enabling mgmt via wireless
Enabling Provisioning SSID
SSID: CiscoAirProvision, Admin Status: 1, Interface Name: management, 802.11 Auth: WPA2-PSK, Wi-Fi Protected Access : Enabled
(Cisco Controller)
Cisco Aironet 3800 Series Mobility Express
Welcome to the Cisco Wizard Configuration Tool
Use the '-' character to backup
Thanks
Steve Chapman
