Folks,
I'm trying to configure Hyperflex replication network pair between cluster
replication network will be using different vlan on each cluster
let say site A using vlan 248 and site B using vlan 249 (both routable between cluster)
since replication vlan already add to UCSM and ESXI I chose existing vlan
but when adding IP range, error appear "Pre Replication Network Configuration validation failed. IP address: 10.1.248.14 is already in use. Please verify there are no duplicate IPs"
no matter which IP range used it always say the fourth IP is duplicate
for example If I start with 10.1.248.100 it will say 10.1.248.103 is duplicate
replication vlan is newly created and I can assure no device using the fourth IP
I really appreciate any insight regarding this issue
Thanks
Budi
