01-11-2019 10:39 AM - edited 03-01-2019 05:44 AM
I am running ACI 4.0.1(h) with vCenter 6.7 and have installed AVE 2.0.1a-r2. I have my VMM configure and AVE installed on vCenter which looks like it is up and running. I have communications with EPs as I would expect.
I am learning about Opflex and how it communicates with the switches. My AVE vm says it is online and I see my vms (vemcmd show port) but when I issue "vemcmd show opflex" this is the output I get.
Status:12 (Active)
Channel0: 12 (Active0, Channel1: 9(Send id)
Dvs name: comp/prov-VMware/ctrlr-{abc-AVE-POCv11}-LABVC07/sw-dvs-344
Remote IP: 10.252.0.30 Port:8000
Infra vlan: 3252
FTEP IP: 10.252.0.32
Switching Mode: LS
Encap Type: VLAN
NS GIPO: 0.0.0.0
My question is on the second line of that output. How do I troubleshoot the channel that has (send id). I know the different levels of getting to an active state, I just dont know the commands to tshoot it and fix it. Any docs would be helpful.
Thx, -Bill
Solved! Go to Solution.