01-28-2019 02:53 AM
Hello All,
I have trouble when I entering config mode with newly bought ISR 4221/K9.
The IOS version is "isr4200-ucmk9.16.9.3.SPA.bin" which was installed from the first.
After router was booted, I tried to hit "configure terminal" but it failed with the error message "This command is not supported".
Also when I tried to hit “wr erase”, "copy A B", etc, the result was same.
Only I can see is “show run”, “show version” and so on.
After a few minutes, I hit “exit” and when I saw the “Press RETURN to get started.” I hit enter.
Then the router asked me the “Username/Password” even though I did not set the username and password.
Is there anybody had a same issue?
I googled but nothing related this issue was found.
Is there anything changed after this IOS version was released?
please advise me.