Hi everyone ,
i am quite new . I have been stuck up from quite few days . i have to implement a solution for the below requirement .
1) i have 15 devices with same ip address ( ip address is hard coded inside and can not e changed ).
2) each device need to communicate with a PC.
3) device don't need to communicate with themselves. they just need to communicate with PC.
4) we are allowed configure PC to Static or dhcp ip .
How to achieve this ? any kind of recommendation would be very helpful
-------------------------------------------------------------
-> also i was already looking at nat solution but not sure which switch would be able to perform this job.
-> also not sure which architecture would be good without router or with router
Hi ,
The customer devices have same ip.
What they want is to either recognise the device using the switch port to which it device is connected or to generate a maksing ip which can be used in place of device ip to connect to a device .
2) The pc is on the same network and we are free to select any ip static or dynamic to it.
