04-12-2019 07:26 AM
SNMP v3 Polling Configuration with ISE v2.4 P7
Hey
Im trying to setup a SNMP v3 polling for ISE from my switches.
I have got SNMP v3 to work with Cisco Prime, but the same settings don't seem to apply to Cisco ISE.
Under "Administration-System-Deployment-Nodes-Profiling Configuration" I have activated SNMPQUERY and SNMPTRAP for each node.
Under each NAD i have configured SNMPv3, user, auth, priv.
Each switch is configured with SNMPv3
view- group ISO included
group - read, write, notify and context vlan- match prefix
user - user group version auth priv.
Then snmp-server host <IP> version 3 priv <user>
Enable all traps.
mac address-table notification change
mac address-table notification mac-move
Since it works with Prime it should work with ISE.
In ISE if I go to Context Visibility - Network Devices, and try to poll a "port config status" I only get error
Opening the report it says under status "Device IP address is not reachable".
But since the switch is added and works with ISE i think its reacheable... ;)
Have I forgot any commands or settings in ISE?
How do i do a SNMPv3 connectivity check in ISE?
Solved! Go to Solution.