cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Who Me Too'd this topic

SG550X stacking issue

andyp
Level 1
Level 1

We currently have a Cisco SG550-48P in our main Data center.  Recently we purchased another one for our second campus across town to replace a SG300-28P that is the core at that site. Currently the SG550-48P is connected to the SG300-28P via Single Mode Fiber using a set of MGBBX1/MGBBX1D SFP modules.  This has been in place for a little over a year and has worked perfectly.  We want to be able to create a horizontal stack between these two sites using the new SG550-48P that we purchased a couple of months ago.  I have the 2 Combo ports (XG1 and XG2) configured as the stack ports on the SG550-48P's and have had them stacked using a Cat6 jumper between the 2 switches in the XG1 ports in the Data center and the stack has been up and operational.  Yesterday after hours, we took the new SG550-48P switch to site B and moved the MGBBX1/MGBBX1D sfp's and fiber jumpers to the XG1 port on both switches and we cannot get the stack to come up and i do not see any activity on the XG1 ports on either switch. I know the SFP's and fibers are good as if we move them back to the XG4 port on the SG500-48P switch in the Data center and the GE28 port on the old SG300-28P switch, the link comes back up and works perfectly.  I have dug through the logs on the SG550-48P and cannot find anything pointing to an issue here.  Also, I was wanting to verify there was not something wrong with the SFP port on either of these switches in the XG1/XG2 ports, but cannot find any command or anywhere in the GUI that shows the optical module status for the configured stack ports.  Any help would be appreciated. 

Who Me Too'd this topic