dear all,
I was trying to get familiar with the 9200 series with but now I'm stuck. It is about the 9200L-24P switch
I have peformed a factory reset with command "factory-reset all". The switch is now in factory mode without any IOS. It stays in the rommon mode.
To load a IOS I want to use the TFTP for transfer
below are steps that I try to perform. please review the steps and advice
step 1 check directory
switch: dir
usage:
dir <path-to-directory>
supported filesystem(s):
flash: ro flash
usbflash0: rw front-panel USB 0
usbflash1: rw front-panel USB 1
switch: dir flash:
Attributes Size Name
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
step 2 set IP iddr to communicate with the TFTP server for the IOS transfer
set ip_addr 192.168.1.100/255.255.255.0
set BAUD 115200
setp 3 verify communication with the TFTP server
ping 192.168.1.10
switch: set ip_addr 192.168.1.100/255.255.255.0
switch: ping 192.168.1.1
ICMP: Set ip-address before using ping!
Failed to ping 192.168.1.1
the communication has been failed. What can go wrong here, because is should accept the IP addr ( cable is tested, same subnet )
step 4 boot the switch from the tftp
boot tftp://192.168.1.10/cat9k_lite_iosxe.16.10.01.SPA.bin
step 5 copy the ios to the flash a
copy tftp://192.168.1.10/cat9k_lite_iosxe.16.10.01.SPA.bin flash:
step 6
how can I let the switch boot from the flash at the next restart, because it will be booted from the TFTP.
errors
when I try to set an IP address, the switch is not remembering the IP. Because this should be set first.
even when I try to load it from usb, it is asking to format in the MBR mode fat 16.
please help/advice
