Hi,
We currently have a mix of Cisco switches from 2960s, 2960X and now the 9200L. However we are having issues with our Paxton POE door controllers.
The 2960s work with all of our Paxton Controllers
The 2960X up to hardware version 4 work with the Paxton POE controllers.
2960X Hardware version 5 and higher and 9200L will not power up the Paxton Controllers.
Has anyone else seen this issue? We are currently rolling out more Paxton controllers and struggling to keep up with the demand on power injectors.
Switch details:-
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 52 C9200L-48P-4X 16.11.1 CAT9K_LITE_IOSXE INSTALL
Here is the power inline details:-
****#show power inline gig 1/0/23 detail
Interface: Gi1/0/23
Inline Power Mode: auto
Operational status: on
Device Detected: yes
Device Type: Ieee PD
IEEE Class: 4
Discovery mechanism used/configured: Ieee and Cisco
Police: off
Power Allocated
Admin Value: 30.0
Power drawn from the source: 15.4
Power available to the device: 15.4
Actual consumption
Measured at the port: 0.0
Maximum Power drawn by the device since powered on: 0.0
Absent Counter: 0
Over Current Counter: 0
Short Current Counter: 0
Invalid Signature Counter: 0
Power Denied Counter: 0
Power Negotiation Used: None
LLDP Power Negotiation --Sent to PD-- --Rcvd from PD--
Power Type: - -
Power Source: - -
Power Priority: - -
Requested Power(W): - -
Allocated Power(W): - -
Four-Pair PoE Supported: No
Spare Pair Power Enabled: No
Four-Pair PD Architecture: N/A
