Hi,
i will install the EWC module on my brand new C9115AXI-E Access point, because is the only Cisco device in my environement.
First i connect the serial cable from AP command line port to my computer and open Putty.
After i connect the Lan cable from my POE at injector to the power port of AP.
In Puttty i see the startup of AP but there also after some minutes i can access the prompt line.
The AP remains in a loop and don't leave the possibility to do something.
I try many times the factory reset with +20seconds and +30seconds hold the reset button.
Anyone can help me out of trouble?
[*03/20/2020 21:10:19.8500] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:24.8570] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:29.8640] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:30.8700] Resetting wired0 and restart DHCP client
[*03/20/2020 21:10:36.8900] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:41.8970] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:46.9050] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:47.9110] Resetting wired0 and restart DHCP client
[*03/20/2020 21:10:53.9300] Waiting for preferred uplink IP configuration
[*03/20/2020 21:10:58.9370] Waiting for preferred uplink IP configuration
[*03/20/2020 21:11:03.9440] Waiting for preferred uplink IP configuration
