01-10-2006 11:31 AM - edited 07-04-2021 11:29 AM
Here is the state the 1200 is currently in. Any help would be appriciated in getting this back.
Thanks in advanced.
Xmodem file system is available.
flashfs[0]: 128 files, 7 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 1490432
flashfs[0]: Bytes available: 6251008
flashfs[0]: flashfs fsck took 9 seconds.
Reading cookie from flash parameter block...done.
Base ethernet MAC Address: 00:12:43:43:7a:33
Initializing ethernet port 0...
Reset ethernet port 0...
Reset done!
link auto-negotiating....
auto-negotiation takes 10000 milli-seconds to complete
ERROR: timeout waiting for auto-negotiation to complete
ERROR: fail to bring ethernet link up
The system has been encountered an error initializing
ethernet port. You may need to check hardware
The system is ignoring the error and continuint boot.
If you interrupt the system boot process, the following
commands will reinitialize ethernet, tftp, and finish
loading the operating system software:
ether_init
tftp_init
boot
Loading "flash:/update/c1200-k9w7-mx.122-15.XR1/c1200-k9w7-mx.122-15.XR1"...####
################################################################################
######################################bad mzip file, unknown zip method
Error loading "flash:/update/c1200-k9w7-mx.122-15.XR1/c1200-k9w7-mx.122-15.XR1"
Interrupt within 5 seconds to abort boot process.
Boot process failed...
The system is unable to boot automatically. The BOOT
environment variable needs to be set to a bootable
image.
C1200 Boot Loader (C1200-BOOT-M) Version 12.2(8)JA, EARLY DEPLOYMENT RELEASE SOF
TWARE (fc1)
TAC Support: http://www.cisco.com/tac
Compiled Wed 12-Feb-03 15:23 by hqluong
ap: