02-15-2021 08:04 AM - edited 02-15-2021 08:05 AM
Hi,
I'm getting stuck with the access points in my CBD setup, perhaps someone can point me in the right direction.
The access points remain offline in CBD, and although I have wireless networks configured I only see the CiscoBusiness-Setup SSID.
Both the 140AC and 240AC show the same behaviour.
In the supported device list for CBD both AP's support all options except the embedded probe.
When looking the Enabled Devices list in CBD under Network Plug and Play the device status remains pending. I think this is because there is no configuration template present for AP's.
So, anyone who can give me a nudge in the right direction?.
I'm running CBD version 2.2.2 and both AP's have firmware version 10.3.1.0 installed.
Regards,
Niels