Hello,
I have an AP 2802i that worked perfectly until was rebooted and now is not booting.
I did found the bug "CSCuy03596" , but no solution for.
I cannot request replacement because of missing contract support for APs.
Do you have a solution for updating the firmware from u-boot?
Message is:
[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)
[*07/19/1986 05:02:02.1300]
[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)
[*07/19/1986 05:02:02.1300]
[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)
[*07/19/1986 05:02:02.1300]
[*07/19/1986 05:02:02.1300] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)
[*07/19/1986 05:02:02.1301]
[*07/19/1986 05:02:02.1301] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)
[*07/19/1986 05:02:02.1301]
[*07/19/1986 05:02:02.1301] (write)Unable to open I2C device interface (/dev/act2) for ACT2 (file = -1)
[*07/19/1986 05:02:02.1305]
[*07/19/1986 05:02:02.1305] (ACT2Boot) Hardware is NOT Cisco (c) authentic
[*07/19/1986 05:02:02.1306] System will reboot in 10 seconds ...
[*07/19/1986 05:02:12.1319] ... rebooting now!
