07-05-2021 02:38 AM
Hi,
Looking for some help regarding a problem with the above message received. The supervisor card is a WS-SUP720 in a WS-6513 chassis. I have changed the default boot file to a bootable image, which works when prompted at ROMMON. However, when disconnected from power and powered back on, it is unable to automatically boot and instead presents this error message.
I believe it is this NVRAM corruption error that's preventing progress, though there might be other factors. I have looked at suggestions from another user and tried to swap the supervisor to another slot, but I receive the same error.
Below is a copy of the CLI output, Thanks:
Testing lower main memory - data equals address
Testing lower main memory - checkerboard
Testing lower main memory - inverse checkerboard
Clearing lower 16k memory for cache initialization
Clearing bss
Reading monitor variables from NVRAM
Warning: Rommon NVRAM area is corrupted. Initialize the area to default values
Enabling interrupts
Initializing TLB
Initializing cache
Initializing required TLB entries
Initializing main memory
Sizing NVRAM
Initializing PCMCIA controller
Exiting init
Cat6k-Sup720/SP processor with 524288 Kbytes of main memory
rommon>
System Bootstrap, Version 7.7(1)
Copyright (c) 1994-2003 by cisco Systems, Inc.
Solved! Go to Solution.