Greetings everyone, so I have 2 port channels configured with trunk ports on my core switch in packet tracer. I allow Vlan 10 on these port channels but I run the "Show int trunk" command I realized that "Vlans allowed and active in management domain" lists as "none. I believe as a result vlan 10 is not being traversed across See script below:
Port Mode Encapsulation Status Native vlan
Po1 on 802.1q trunking 1
Po2 on 802.1q trunking 1
Port Vlans allowed on trunk
Po1 10
Po2 10
Port Vlans allowed and active in management domain
Po1 none
Po2 none
Port Vlans in spanning tree forwarding state and not pruned
Po1 none
Po2 none
