Routers - Small Business

Hi folks, I have a small business RV130W and have configure it. All works good on wireless with captive portal until this morning. When users onnect to SSiD, all is ok, but when they open a browser they are not redirect anymore to the captive portal ...

I am trying to set up a site to site VPN between RV130 routers. I am using static IP addresses on both sides and have them setup with the Basic VPN configuration. I have enabled logging and are receiving the following log message (IP addresses have b...

Hello,I could established a VPN tunnel over IPsec from Digi WR21 to Cisco RV082 and the data flows correctly. Anyway, VPN break information from time to time appears on Cisco WebUi page. What can be the root of this?Data flow is not affected by this,...

Dear Mr/Mrs, I bought cisco rv130w wifi vpn router in HK, my question is 1. Must it use DNS to connect WAN? 2. Does the wifi also need to put DNS server for internet? Best Regards,Kenneth 

So I've been trying to configure NTP for a while and I've asked a few people and nobody knows whats wrong so I decided I'd ask you guys Pretty much NTP just wont work, I don't get any packets back in (From what I can tell)    So here is my NTP config...

i have setup PPTP on a Cisco RV215W router.  i can gain remote access to the router with no issue, but i am not able to access any device past the router.  I have 2 vlans, 40 and 41.  I have inter vlan routing enabled,  on vlans 1, 40, 41, i have a t...

I've been browsing the discussion groups, and it seems that the RVS4000's VPN feature doesn't support the iPhone. I have one of the new V2 models. Does the V2 model's VPN support the iPhone, or do we still have to look elsewhere for iPhone VPN suppor...

I have a RV180 router that I bought to replace a befvp41 that I suspect is going bad.  I want to install this at our main business site and acceptVPN connections from 3 different remote sites.  I have set the advanced vpn to be a responder and config...

Every time i try to transfer a file over VPN of approx. 5mb or more the transfer fails with the error code 0x8007003B. Does anyone know what might be the cause?

I have a 300mbps capable modem that supports my 200mbps service. When I do a speed test connected directly to the modem I get full speed - 200mbps download and 20mbps upload. But when I do a speed test after connecting my RV180W router I get 20mbps ...

Hello, I manage some RV Types with QuickVPN in the field and there was no Problem to connect the host behind the RV Routers.Now I have the RV110W with newest Firmware 1.2.1.4. I can connect the Network with the QuickVPN client sucessfully. I Can ping...

I have a problem in one to one NAT configuration on the RV320 router.I've done many times and I can not finish, the reason is that after I give an add add the IPs range etc. when I put to save unsaved. Nothing happens, no error message with. Already ...

Setup RV042 in load balance mode with two DSL connections.  Configured each connection with its own seperate static ip.  When Outlook 2010 is opened it comes up with an error " Your system does not support the encryption type you specified".  Also ca...