Routers - Small Business

Hello,I have a problem with 2 users in the home network who overuse the internet. They constantly watch YouTube with Pandora turned on or other streaming content.We have RW110. How can I limit their bandwidth, so when they use the internet they do no...

Hi all,This is my first post on these forums so please bear with me.  I just began using Cisco's small business products and have loved them all until I tried the RV180W.  First of all, getting an internet service in the location of this installation...

Hello,I had something strange happen to my WRVS440N router yesterday. Our network had crashed for some reason. I asked someone to reset the router by pulling the power cable and then reinsterting it. This didn't seem to work. So I attempted to log in...

RV082 configured for Dual WAN(2) identical DSL connections, configured as Static IP (not PPPoE) with modems in bridged mode.Static IP's are /25 subnet and same gateway  ** this may be a problem?Dual WAN set for Load Balance, network service detection...

Ok I'm Stuck!  I need to route mail to a different port.  I found that UPnP is the only place to enter a different end port.  However, I can't figure out how to enter the access rule for that service.  I have researched the forums and found the UPnP ...

Hi,I have upgraded to the new RV042G to take advantage of the gigabit ethernet speeds and to prepare for when our ISP upgrades our bandwidth. I currently use the RV042 with ProtectLink enabled to filter out various categories from our network traffic...

Here's what I want to do with my RV042: I have a bunch of devices, including a server, inside my network at 192.168.1.100I've set up VPN using PPTP. It works, but if my clients have their own remote DHCP set up to 192.168.1.x, they can't get to the s...

Is there a way to identify which port is hosting the assigned DHCP address?  I have looked at the statuses for both ports and DHCP, but can see no identifiable info to pin it down.  the system log only shows the wan settings.I would simply pull cable...

I work for a company that recently upgraded to a Cisco RVS4000 router in place of a failing D-Link router.  I configured the RVS4000 to utilize the same address space as the D-Link previously did (192.168.0.0 Network Address, 255.255.255.0 Subnet Mas...

When I use QuickVPN under XP, I connect to my RVS4000 without problems.  When I switch to new computer running Windows 7 and V4.2.1 QuickVPN I can get all the way to Verifying Network.   Then I get the message that: "The remote gateway is not respond...

Hi first time poster and Cisco forum user -  although I hasten to point out that I have owned and used an 'IBM' type PC since 1988 and have always managed to get things configured correctly until NOW! ...and have never been so frustrated - apart from...

am logging hundreds of warnings at times --under status, dashboard, syslog summary, "warning"    when I click the active "warnings" entry, it takes me to the syslog area, where all is blank.I've been having problems with the device going non-responsi...

Hello,I recently bought the RV180W for the sole reason to be able to access my LAN remotely. With the hardware I have, I can either setup PPTP VPN connections or use Cisco QuickVPN software. Ideally, I would rather use the PPTP VPN since it doesn't r...

why my device "cisco RVS4000" loses settings after some down time without electricity?