Dear all,
I already configure the RV016 router as twogateway ISPs. With the following configuration:
WAN1 using static ip from the ISP that is 202.69.7.2/30
WAN2 also use static ip from ISP 119.56.78.113/30 (for this link is a broadband link)
DMZ use the ip 202.54.99.1 - 202.54.99.14 mask 255 255 255 224
Gateway to the DMZ through WAN1 while WAN2 ip only broadband that can not be called from the Internet.
VPN also been configured for the Gateway to Client, QuickVPN client and PPTP VPN client.
Configured for LAN with a dhcp ip 192.168.2.254/24 192.168.2.100 - 192.168.2.200 mask 255.255.255.0
The problem is in vpn. Once users access the vpn to the router via ip 202.69.7.2 on RV016, in a way Gateway to VPN Client, QuickVPN, or PPTP. Vpn user can not access the existing ERP applications on the LAN. ERP applications can be accessed from the LAN is also connected to another router. The router of ERP applications has a configuration like this:
LAN using the ip 192.168.2.250/24
WAN using ip 10.5.4.2
ERP applications using ip 10.4.2.139
From WAN into LAN using NAT masquerade
Users who use the LAN can access the ERP application. But why the vpn user can not get to the ERP application that uses the router.
I've tried to trace the route of using a PPTP vpn client to the ERP application by adding route add command on my laptop. Trace route successfully but failed to connect the ERP application. What is missing from my config for vpn in.
Regards,
Dwi
