I just recently purchased a new NAS with two LAN Ports built into it. I plugged into both ports from two ports on my RV082 router (Ports 1&5). I was able to successfully bound those ports together on the NAS device. However my bandwidth didnt seem to improve. I was told by netgear support I needed to enable LACP on my router. I did not see how to do that or anything similar. The best i could find was setting High Priority tow LAN ports 1 and 5....any assistance would be helpful or any type of solution which will allow me to increase the bandwidth through those ports
Does someone know if the (newer) RV series supports LAG ?
Searching the admin guide doesn't pop up any hit.
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: