cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
399
Views
0
Helpful
1
Replies

Enable nbar2 on zone base firewall - cisco 881

shehanfernando
Beginner
Beginner

IOS version :- c880data-universalk9-mz.154-3.M4.bin

I'm looking to enable NBAR2 on cisco 881 router according to this doc . I couldn't find command called "nbar-classify" inside the following parameter-map command. Appreciate any feed back to fix this

(config)#parameter-map type inspect global 

1 Accepted Solution

Accepted Solutions

Philip D'Ath
Advisor
Advisor

You missed this important bit.

In Cisco IOS Release 15.5(1)T and later releases, zone-based firewalls supports Network-Based Application Recognition 2 (NBAR2).

View solution in original post

1 Reply 1

Philip D'Ath
Advisor
Advisor

You missed this important bit.

In Cisco IOS Release 15.5(1)T and later releases, zone-based firewalls supports Network-Based Application Recognition 2 (NBAR2).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers