cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
547
Views
0
Helpful
2
Replies

help with rv082

albertldee
Level 1
Level 1

i have the RV082 v03 i set it for load balancing i have 2 8gb Adsl modem connected to Wan1 and Wan2

Question how can i assign a certain pc to use the connecton on Wan2, what i would like is to assign a specific pc on the network to wan2 

2 Replies 2

Te-Kai Liu
Level 7
Level 7

Look for the protocol binding settings under System Management>Dual WAN>Edit WAN2.

With a ptotocol binding rule, you can bind all traffic originating from a given IP address to WAN2.      

jurodri3
Level 1
Level 1

Hello Alber Idee,

Let me share with you some information found on the guide me section about protocol biding configuration step by step.

I hope this information helps you.

http://sbkb.cisco.com/CiscoSB/ukp.aspx?vw=1&docid=69b1889ee61d42bb9a389bf69fb7bf28_Priority_Bandwidth_magement_using_Rv042.xml&pid=4&fcid=&fpid=&slnid=3

If this answer was satisfactory for you, please mark the question as Answered.

Diego Rodriguez

Cisco network engineer

Thank you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: