How to run Console on RV340P cisco router

[elkanahomonitan]

How to run Console on RV340P cisco router

[Devaa]

You can get into WebUI with any browser in your PC connected to one of the LAN port of the router. 

• Turn ON router and make sure the PWR LED is solid green and the port LEDs are green or blinking green.
• You connect a straight-through cable to an Ethernet port on the router.
• Any pop-up blockers or proxy settings on your browser are disabled and that any wireless client is disabled on your PC or laptop.
• Your PC settings use DHCP. The router acts as a DHCP server. If your PC has a static IP address, temporarily configure your PC settings to use DHCP.
• Launch a Web browser and enter the IP address “https://192.168.1.1” into the address bar, then press Enter key.

https://www.cisco.com/c/dam/global/en_au/solutions/small-business/pdfs/cisco-rv340-series-security-router-easy-setup-guide.pdf

[Flavio Miranda]

@elkanahomonitan 

This router did not support console connection until couple of years back, althouth It has the console port. Not sure If It has changed. 

 If you have a console cable, you can try. If you do not succeed, probably Cisco end up not enabling it

Baud Rates: 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200

Data bits: 8

Stop bits: 1 and 2

Flow control: None, XOFF,XON, Hardware

Parity: none

[elkanahomonitan]

Which Cisco routers have a web-based management interface and also support
a console for running commands? Please also attach a sample of the web
interface for the Cisco 345P

[Flavio Miranda]

Do you mean this

Older version of cisco router were CLI mode only. Now a days all cisco device support some sort of web interfaces and models like RVXXX actually was made to be manage via GUI. 

But router like ISR1000 also have a good GUI interface