02-18-2013 12:46 PM
Hi,
I found this guide in order to send all traffic from RV042 branch office to the RV082 in the central office:
But that guide is for v2 hardware. I tried and did not work, so I wonder if there is newer info for v3 hardware (firmware v4.2)
I have a RV042 in a brach office connected via working VPN Tunnel to a RV082 central office. I want to route all traffic
from the brach office to the RV082 in the central office.
Many thanks
Oliver
Solved! Go to Solution.
02-18-2013 01:00 PM
Hi Olivers, this is called esp wild card forwarding (full tunnel).
Here is a couple helpful topics
https://supportforums.cisco.com/message/3766661
https://supportforums.cisco.com/message/3816181
-Tom
Please mark answered for helpful posts
02-18-2013 01:00 PM
Hi Olivers, this is called esp wild card forwarding (full tunnel).
Here is a couple helpful topics
https://supportforums.cisco.com/message/3766661
https://supportforums.cisco.com/message/3816181
-Tom
Please mark answered for helpful posts
02-19-2013 08:31 AM
Thanks, its seems is the same configuration for the v3 hardware.
Remote should be 0.0.0.0 in order to sent all traffic to the other side.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: