cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
758
Views
0
Helpful
2
Replies

How to sent all traffic via VPN, RV082 v3 hardware

oliversl1
Beginner
Beginner

Hi,

I found this guide in order to send all traffic from RV042 branch office to the RV082 in the central office:

https://supportforums.cisco.com/servlet/JiveServlet/downloadBody/10261-102-1-22927/Small_Business_router_tunnel_Branch_to_Main.doc

But that guide is for v2 hardware. I tried and did not work, so I wonder if there is newer info for v3 hardware (firmware v4.2)

I have a RV042 in a brach office connected via working VPN Tunnel to a RV082 central office. I want to route all traffic

from the brach office to the RV082 in the central office.

Many thanks

Oliver

1 Accepted Solution

Accepted Solutions

Tom Watts
Advisor
Advisor

Hi Olivers, this is called esp wild card forwarding (full tunnel).

Here is a couple helpful topics

https://supportforums.cisco.com/message/3766661

https://supportforums.cisco.com/message/3816181

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post

2 Replies 2

Tom Watts
Advisor
Advisor

Hi Olivers, this is called esp wild card forwarding (full tunnel).

Here is a couple helpful topics

https://supportforums.cisco.com/message/3766661

https://supportforums.cisco.com/message/3816181

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

Thanks, its seems is the same configuration for the v3 hardware.

Remote should be 0.0.0.0 in order to sent all traffic to the other side.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers