04-04-2016 04:27 AM
Hi there,
Hope this message finds you fine. I have a problem with my RV325 VPN WAN Router. I have four remote users connect through Cisco VPN client to the server. I did the setup of VPN and it worked fine, But it only allow 2 users to access my network. Only 2 and the Router supports 25 VPN user. How can I increase the number of tunnels connected to the Router.
And one more thing.. After along time of disconnecting the Client. Remote users cannot reconnect to with VPN unless I restart the Router. and then everything works fine. So, I have to restart the Router everyday so the remote users can reconnect to the server.
- How to setup more tunnels to VPN ?
- How users can easily connect to VPN without the need to restart the Router?
Kindly find the attach files regards to the Print Screen Configuration.
Thanks in advance
04-04-2016 08:58 AM
Hi
You write :
"After along time of disconnecting the Client. Remote users cannot reconnect to with VPN unless I restart the Router. and then everything works fine. So, I have to restart the Router everyday so the remote users can reconnect to the server"
Post your screenshot, the RV320 firmware is 1.3.1.10.
I have the same problem, I should restart my router every day.
The firmware did not appear stable,
I returned on a firmware 1.2.1.14, my VPN connections are functional again.
Cordially
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide