Meraki MX64 VPN Client

[mr.sajid]

Hi,

I have CISCO Meraki MX64 and "Client VPN" (under Security and SD-WAN) is configured properly. Hence I can connect and authenticated to it using VPN client from Windows 10. Everything works perfectly fine for a about half a minute but after that all traffic stops and I can't even ping or browse anything. What could be the reason for this issue? 

Kindly suggest a solution. 

Thanks a lot, 

Sajid 

[marce1000]

 - Check the logs on the Meraki-device , check if  you can find anything that relates to your problem

M.

[mr.sajid]

Thanks for your kind response. Nothing shows up in it's log which relates to this issue. 

[brywhite]

This is still an issue for the MX95.  The Windows native client VPN works, the Cisco Secure Client (legacy v5.0.01242) works, but the Cisco AnyConnect Client (Universal Windows Platform fpr Windows 10/11) available from the Microsoft Store does not.  The client will connect and authenticate but disconnects after less than a minute w/o any error message or log entires.

[STD_NetWorld]

@mr.sajid Could you confirm few configuration on SD-WAN --> client vpn --> anyconnect setting ?

1. DNS nameservers
2. Client Routing
3. Dynamic Client Routing
4. Default Group Policy

And have you configured any policy for anyconnect Subnet on SD-WAN--> Firewall?