Protocol Binding

[bob.wakelin]

How do I bind POP and SMTP email protocols to WAN2 on a Cisco RV345P?

[ktonev · Accepted solution]

Hello Bob,

You need to go to WAN > Multi-WAN > Policy Binding Table and click on Add.

After that you need to specify the Source and Destination IPs, the Service type (POP or SMTP), the outgoing interface (WAN2) and whether you want Failover to backup WAN.

Thanks,
Kris

If you found this information useful please rate it so other users can benefit as well.

[bob.wakelin]

That seemed to do the trick. Thanks