Router 888 L3 interface missing

[tafa]

Hello, I just bought a CISCO 888 router and I am trying to configure it for a very first time. The problem is that I need the L3 port for NAT but the router shows me only the L2 ports (0-3).

 

 

[MHM Cisco World]

try under the L2 interface 

no switch port <<- this make L2 port as L3 interface

[tafa]

Incomplete command

 

[MHM Cisco World]

do you try config IP under the interface if you success then it L3 not L2.

[tafa]

I tried but showed me it is L2

[MHM Cisco World]

can you share 
show IP interface status 

[tafa]

Wrong command 

 

[MHM Cisco World]

Show ip interface breif 

[tafa]

 

[MHM Cisco World]

so you dont have WAN interface you have BRI 
I think you can config IP under the BRI interface 
interface bri X
ip address 

[tafa]

So the cable go in to SHDSL port? I will configure to receive IP from the ISP. But which BRIE to use?

[MHM Cisco World]

BRI 0 

[tafa]

Still not working:(

 

[MHM Cisco World]

https://www.cisco.com/c/en/us/support/docs/wan/point-to-point-protocol-ppp/10308-bri-mppp.html

OK, since it not accept the config then try config dialer interface and use BRI as HW interface.
check the example above

[balaji.bandi]

follow below guide :

https://www.cisco.com/c/en/us/td/docs/routers/access/800/software/configuration/guide/SCG800Guide/SCG800_Guide_BookMap_chapter_010.html#task_1224393