cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1090
Views
0
Helpful
20
Replies

Router 888 L3 interface missing

tafa
Spotlight
Spotlight

Hello, I just bought a CISCO 888 router and I am trying to configure it for a very first time. The problem is that I need the L3 port for NAT but the router shows me only the L2 ports (0-3).

received_412819190826322.jpeg

received_1446379565828093.jpeg

20 Replies 20

try under the L2 interface 

no switch port <<- this make L2 port as L3 interface

Incomplete command

16599022224605158532068973699124.jpg

do you try config IP under the interface if you success then it L3 not L2.

I tried but showed me it is L2

can you share 
show IP interface status 

Wrong command 

16599061991819124545626777741206.jpg

Show ip interface breif 

16599074545516878238684880794007.jpg

btobto.png

so you dont have WAN interface you have BRI 
I think you can config IP under the BRI interface 
interface bri X
ip address 

So the cable go in to SHDSL port? I will configure to receive IP from the ISP. But which BRIE to use?

BRI 0 

Still not working:(

16599120254558467137963327199105.jpg

https://www.cisco.com/c/en/us/support/docs/wan/point-to-point-protocol-ppp/10308-bri-mppp.html

OK, since it not accept the config then try config dialer interface and use BRI as HW interface.
check the example above