My Cisco RV042 router cannot perform their featured functionality in either Smart Link Back up or Load Balance modes.
E.g a) In load Balance Mode WAN 2 will be tunnelingtrafic as primary even though WAN 1 is actually the primary tunnel.
b) In Load balance (auto) Mode, traffic will continue to be tunneled through say WAN 2 port even though the bandwidth on that network has been saturated. Packets will not be spilled over to the other WAN port i.e WAN 1 in this scenario.
Attemts for a solution:
a)Upgraded the Firware to version 4.2.3.03-20140319 on one of the units but this attempt could still not resove the issues. The other units came up with a "connection to device time out" each time I attemped to do a firware upgrade.
b)I reset to factory default but the issues remain the same.
I will be grateful if you can suggest a way foward on this problem.
Robert