cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1155
Views
0
Helpful
5
Replies

Router RV160W no puedo conectar VPN PPTP

CarlosSosa96707
Beginner
Beginner

Estimados agradeceré la ayuda sobre el tema, actualice el Firmware del RV160W con la ultima version 1.0.01.1, intento configurar una VPN PPTP y en faltan opciones de configuracion o si intento realizar una VPN Ipsec no logro la comunicación, seguí en esta ultima algunas configuraciones en pdf que están en la web pero continuo con el problema, agradeceré algún instructivo para configurar VPN PPTP e Ipsec con este Firmware que aparentemente es diferente

Tengo otras VPN funcionando pero ninguna con este modelo de router ni version de Firmware.  Terminan todos mis intentos en la imagen que adjunto

Muchas gracias

1 Accepted Solution

Accepted Solutions

Martin Aleksandrov
Cisco Employee
Cisco Employee

Hi Carlos,

 

Here is a more recent step-by-step configuration for the PPTP on RV series. The following example is for RV34x but both RV340 and RV160 share the same PPTP configuration settings. 

 

https://community.cisco.com/t5/small-business-support-documents/pptp-vpn-configuration-on-rv340-345-routers/ta-p/3220097

 

Regards,

Martin

View solution in original post

5 Replies 5

marce1000
VIP
VIP

 

 - Check if this demo-guide can help you :

            https://www.youtube.com/watch?v=ICMlmuw-ucg

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

Martin Aleksandrov
Cisco Employee
Cisco Employee

Hi Carlos,

 

Here is a more recent step-by-step configuration for the PPTP on RV series. The following example is for RV34x but both RV340 and RV160 share the same PPTP configuration settings. 

 

https://community.cisco.com/t5/small-business-support-documents/pptp-vpn-configuration-on-rv340-345-routers/ta-p/3220097

 

Regards,

Martin

Thank you very much Martin, it worked ok

Greetings

 

Muchas gracias Martin, funicono OK

Saludos

Carlos Sosa

You're welcome! 

Dear Martin, I bother you again, because when I generate connections from Windows 10 or Windows 7, the existing Internet connection is disconnected from where I configure the VPN connection for a minute and then it is impossible to navigate, but strangely I can access one of the terminals within the network that continues to be remotely connected by the VPN in the subnet configured on the VPN server.

Greetings

Carlos Sosa

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: