10-16-2012 07:14 AM
I have both WAN1 and WAN2 connected to an ISP but only WAN2 should be used for outgoing mails.
How and where can I specify this in the configuration?
Solved! Go to Solution.
10-16-2012 07:21 AM
You can configure a protocol binding rule to bind smtp to WAN2 at the System Management>Dual WAN>Edit WAN2 page.
10-16-2012 07:21 AM
You can configure a protocol binding rule to bind smtp to WAN2 at the System Management>Dual WAN>Edit WAN2 page.
10-16-2012 07:25 AM
I did that, see below but it still goes to WAN1, 192.168.123.2 is my mailserver but why the destination ip's? if you leave them blank you can't add the service
10-16-2012 07:27 AM
got it now correct I think, in the destination range I have filled in 0.0.0.0 to 255.255.255.255
And what happens if WAN2 is not active? will it then try WAN1 ?
Can someone reply to this please?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide